USGW - Services

Our Services

Newest Services

Setups

Adjust truss rod, file nut slots, set bridge height & saddle radius, balance & adjust tremolo, set pickup heights & balance, intonate, tighten tuners & hardware, clean & oil fretboard and polish frets, restring, detail & clean. (Instruments that are exceptionally dirty or have rusty/seized hardware will incur an additional expense). All setups are guaranteed from within 14 days of pickup.

Electric (Tune-o-matic Bridge, Gibson/Epiphone/etc.)	$75
Electric (Fender Style Bridge – 3 or 6 saddles) Add $15 for instruments with truss rod adjustment at the heel	$80
Electric (Floyd Rose Bridge)	$100
Electric (12 String)	$125
Acoustic (6 String)	$75
Acoustic (12 String)	$125
Bass (Add $5 for each additional string)	$65
Rickenbacker Bass	$95
Banjo (4/5 string)	$85/$90
Ukulele/Dulcimer	$65
Mandolin	$95
Violin	Call for Pricing

Setup Services (Discounts apply when combining services)

Restring Electric/Acoustic (6/12 String)	$20/$45
Restring Floyd Rose – 6 String	$30
Restring Classical/Nylon	$30
Truss Rod Adjustment	$20
Truss Rod Adjustment at Heel (Vintage Fender)	$40
Intonate (Electric 6/12 String)	$20/$30
Intonate (Floyd Rose 6 String)	$45
Polish Frets & Oil Fretboard (Requires Restring)	$15
Pickup Adjustment & Balance	$10
Shim bolt-on-neck (requires setup) Standard/Custom	$20/$40

More Services (Discounts apply when combining services

Tuner Install – Direct Fit - 6 string (Requires Restring)	$20
Tuner Install – Custom Fit	(By estimate)
Buff out scratches	(By estimate)
Block Strat style tremolo	$40
Ream bridge pin holes	$20
Route Pickup Cavity on disassembled body	$45
Install Strap Button	$10
Strap Button Repair (drill, plug and redrill)	$30
Align bolt on neck and drill holes	$40
Replace Strat style pickguard	$60
Replace Tele Style Pickguard (pickup attached)	$40
Remove and reglue Acoustic Pickguard	$80

Nuts

Cost of bone material included. Synthetic nut is additional charge. May require truss rod adjustment. New strings recommended. Add $20 for nuts with lacquered edges. Add $120 if re-lacquer is requested

Standard Size Bone or Synthetic Nut (6/12 String)	$80/$120
Custom Size Bone Nut	(By estimate)
Shim Floyd Rose Nut	$45
Install Zero Fret Nut	$80
Fill and File Nut Slots	$10 per slot

Saddles

Cost of bone material included. Synthetic saddle is additional charge. May require new strings, truss rod & nut slot adjustment

Standard Size Bone or Synthetic Saddle (6/12 String)	$60/$90
Custom Size Bone Saddle	(By estimate)
Shim or Sand Saddle (May require nut slot adjustment)	$40
Notch saddles on Tune-O-Matic Bridge to match neck radius	$30

Electronics

Basic Electronic Diagnostic	$40
Tele Bridge Pickup/Neck Pickup/Both	$60/$45/$90
Strat Pickups (Add $5 for each additional Pickup)	$70/$75/$80
Les Paul Pickups (Add $15 for each additional Pickup)	$60/$75
Install EMG/Active Pickups (With pots, jack & battery)	$120
Semi/Hollowbody Pickups	Starts at $100
Install K&K Pickup	Starts at $60
Install Under Saddle Pickup	Starts at $80
Replace Switch	$30 - $60
Replace Volume Pot on Les Paul/Strat	$50
Replace Tone Pot on Les Paul/Strat	$40
Replace Output Jack	Starts at $20
Clean Volume/Tone Pots	Starts at $15
Electrical Shielding Paint (Paint pickup and control cavities and shield back of pickguard/control plates	$90
Tighten Loose Jack on Acoustic (6/12 String)	$40/$60

Fretwork

All fretwork is performed using the Erlewine neck jig.

The Neck Jig allows fret work to be performed on the guitar while simulating string tension, for the most accurate fretting and fingerboard leveling possible!

*Full Fret Level (Level, crown, and polish)*
Unfinished fretboard	$120
Finished fretboard	$150
Full Re-fret. Setup is additional cost. Set neck and Acoustic guitars may incur an additional cost
Unbound Unfinished Fretboard	$300
Bound Unfinished Fretboard	$450
Unbound Finished Fretboard, Bound Finished Fretboard and Fender pre 1980’s necks	(By estimate)
*Partial Re-frets will incur a $80 leveling fee which include a full leveling, crown and*
*polish. Setup is additional cost. May require new nut*
Unbound Unfinished Fretboard	$20/fret
Bound Unfinished Fretboard	$30/fret
Finished Fretboards	(By estimate)
File Sharp fret ends ($30 w/setup. New strings required)	$60
Reseat and Glue lifting frets	$15/each

Bridges

Re-glue/Replace Bridge – Martin/Gibson/Taylor Style (Additional cost if pickup is present)	$150
Re-glue/Replace Bridge – Poly Finish	$200
Re-glue/Replace Classical Bridge	$200
Replace Bridge Pad	$350

Cracks and Braces

Glue Cracked Headstock (Partially attached, includes setup)	$150
Glue Cracked Headstock (Fully separated, includes setup)	$240
Sand and Re-finish Cracked Headstock	(By estimate)
Crack Repair up to 3” w/cleat	$75
Crack repair up to 7” w/cleats	$150
Cracks over 7” w/cleats	By estimate
Reglue loose brace	By estimate

Neck Resets

Taylor NT Neck	$95
Martin	$400
Gibson and Guild	$550
Other Makes	By estimate

Paint Touch Ups

By estimate

*All repairs with the exception of setups are guaranteed for 6 months after completion date.
*Any procedure that does not appear on this list will be billed at the rate of $100/hour. *Above prices do not include parts or strings unless otherwise noted.
*All prices are subject to change after inspection.

Services

Header Content Region

Insert text, image or banner ads here, or just delete this text and leave this area blank!

20% off installation

Welcome to Union Street Guitar Works

Union Street Guitar Works!

Where attention is provided to Services and Satisfaction

Union Street Guitar Works

Using a Erlewine Neck Jig

Bridge Removal

Ukulele